Warning: mkdir(): No space left on device in /www/wwwroot/new6.com/func.php on line 127

Warning: file_put_contents(./cachefile_yuan/qdycyt.com/cache/3e/88276/2e642.html): failed to open stream: No such file or directory in /www/wwwroot/new6.com/func.php on line 115
天然气麻豆性视频网发生下面故障怎么处理？_公司91麻豆女人丰满在线播放_91麻豆女人丰满在线播放中心-济南济柴91麻豆产精品久久久久久夏晴子燃气发电设备有限公司


      • 91麻豆产精品久久久久久夏晴子,麻豆性视频网,麻豆MV在线观看,91麻豆女人丰满在线播放

      欢迎进入济南济柴91麻豆产精品久久久久久夏晴子燃气发电设备有限公司官网！

      公司91麻豆女人丰满在线播放

      天然气麻豆性视频网发生下面故障怎么处理？

      返回 2020.10.27 来源：http://www.qdycyt.com 0
      一、发动机转速不稳
      1、 Unstable engine speed
      1.执行器与节气门间传动杆系卡滞或间隙大：检查并重新安装调整。
      1. Transmission linkage between actuator and throttle is stuck or clearance is large: check and re install and adjust.
      2.发动机超载：降低发动机负载。
      2. Engine overload: reduce engine load.
      3.转速传感器安装间隙过大：检查并重新安装调整。
      3. The installation clearance of speed sensor is too large: check and re install and adjust.
      4.控制器参数调整不当：重新调整增益、微分及状态开关。
      4. Improper adjustment of controller parameters: readjust gain, differential and state switch.
      5.屏蔽线连接不当，出现电磁干扰产生不稳定：检查屏蔽线是否连接正确可靠。
      5. Improper connection of shielding wire leads to electromagnetic interference instability: check whether the shielding wire is connected correctly and reliably.
      二、发动机不能启动
      2、 The engine will not start
      1、节气门卡死：重新安装与调试。
      1. Throttle stuck: re install and commission.
      2、启动油量设定值过低：适当增大启动油量。
      2. The set value of starting oil is too low: increase the starting oil properly.
      焦化麻豆性视频网
      3、转速设定太低：顺时针旋转低速电位器，以提高到怠速状态。
      3. Speed setting too low: rotate the low speed potentiometer clockwise to increase to idle speed.
      4、无转速反馈信号：检查转速传感器及电缆。
      4. No speed feedback signal: check speed sensor and cable.
      5、调速器电源不通或接反：检查电源及接线。
      5. Governor power failure or reverse connection: check the power supply and wiring.
      三、发动机启动超速
      3、 Engine over speed
      1、控制器参数调整不当：适当增大控制器的“增益”和“微分”。
      1. Improper adjustment of controller parameters: properly increase the "gain" and "differential" of the controller.
      2、调速器电流限制过高：适当降低启动油量。
      2. The current limit of governor is too high: reduce the starting oil properly.
      3、执行器与节气门机构减小燃气的方向不一致或者零点位置不匹配：检查并重新安装调整。
      3. Actuator and throttle mechanism reduce gas direction is inconsistent or zero position does not match: check and re install adjustment.
      4、调速系统转速设定过高：调整低速设定值，达到标定设定值。
      4. Speed control system speed setting too high: adjust the low speed setting value to reach the calibration setting value.
      只有把上述所讲的内容设定好，91麻豆产精品久久久久久夏晴子的操作才算完成，如果您这边在后续的过程中有任何的问题，欢迎致电或者是在网站上边留言:焦化麻豆性视频网http://www.qdycyt.com
      If you have any problems in the follow-up process, please call or leave a message on the website: coking generator set http://www.qdycyt.com

      上一条：燃气麻豆性视频网如何确保机组可靠运行？

      下一条： 发电机的常见故障有哪些？

      91麻豆女人丰满在线播放搜索
      济南济柴91麻豆产精品久久久久久夏晴子燃气发电设备有限公司

      • 服务热线

        0531-62325028
        0531-69951266

      天然气麻豆性视频网发生下面故障怎么处理？

      一、发动机转速不稳
      1、 Unstable engine speed
      1.执行器与节气门间传动杆系卡滞或间隙大：检查并重新安装调整。
      1. Transmission linkage between actuator and throttle is stuck or clearance is large: check and re install and adjust.
      2.发动机超载：降低发动机负载。
      2. Engine overload: reduce engine load.
      3.转速传感器安装间隙过大：检查并重新安装调整。
      3. The installation clearance of speed sensor is too large: check and re install and adjust.
      4.控制器参数调整不当：重新调整增益、微分及状态开关。
      4. Improper adjustment of controller parameters: readjust gain, differential and state switch.
      5.屏蔽线连接不当，出现电磁干扰产生不稳定：检查屏蔽线是否连接正确可靠。
      5. Improper connection of shielding wire leads to electromagnetic interference instability: check whether the shielding wire is connected correctly and reliably.
      二、发动机不能启动
      2、 The engine will not start
      1、节气门卡死：重新安装与调试。
      1. Throttle stuck: re install and commission.
      2、启动油量设定值过低：适当增大启动油量。
      2. The set value of starting oil is too low: increase the starting oil properly.
      焦化麻豆性视频网
      3、转速设定太低：顺时针旋转低速电位器，以提高到怠速状态。
      3. Speed setting too low: rotate the low speed potentiometer clockwise to increase to idle speed.
      4、无转速反馈信号：检查转速传感器及电缆。
      4. No speed feedback signal: check speed sensor and cable.
      5、调速器电源不通或接反：检查电源及接线。
      5. Governor power failure or reverse connection: check the power supply and wiring.
      三、发动机启动超速
      3、 Engine over speed
      1、控制器参数调整不当：适当增大控制器的“增益”和“微分”。
      1. Improper adjustment of controller parameters: properly increase the "gain" and "differential" of the controller.
      2、调速器电流限制过高：适当降低启动油量。
      2. The current limit of governor is too high: reduce the starting oil properly.
      3、执行器与节气门机构减小燃气的方向不一致或者零点位置不匹配：检查并重新安装调整。
      3. Actuator and throttle mechanism reduce gas direction is inconsistent or zero position does not match: check and re install adjustment.
      4、调速系统转速设定过高：调整低速设定值，达到标定设定值。
      4. Speed control system speed setting too high: adjust the low speed setting value to reach the calibration setting value.
      只有把上述所讲的内容设定好，91麻豆产精品久久久久久夏晴子的操作才算完成，如果您这边在后续的过程中有任何的问题，欢迎致电或者是在网站上边留言:焦化麻豆性视频网http://www.qdycyt.com
      If you have any problems in the follow-up process, please call or leave a message on the website: coking generator set http://www.qdycyt.com
      网站地图